Note: If your properties pane does not show, type in the command bar “PROPERTIES”. The elevation can be neglected (all set to 0) if we are just going to draw in 2D, but even in that we can utilize positive or negative elevation values to indicate duct rising or dropping. With the MEP toolset, you can: Optimize your workflow with individual palettes and domain-specific ribbons. HVAC and building systems are made easy with an industry-specific toolset for MEP (mechanical, electrical, and plumbing) that increases productivity by up to 85. If you create building mechanical, electrical, or plumbing (MEP) construction documents and are currently working with AutoCAD software to produce your. In this case, we set the rectangular duct at 500(W)x500(H), at an elevation of 3000 (from Floor). The 2023 MEP toolset is included with AutoCAD. Therefore, after our first click and before our second click, hover our cursor to the properties pane to set the properties for this first section of duct. After clicking on your first point, before we move on to the next point to complete the first section of our duct, we specify the properties for this first section of duct at the properties palette. In this case, we are going to route a supply air duct starting from the AHU (Air Handling Unit) in the AHU room. Create engineering designs within an AutoCAD environment. ![]() ![]() Preview is constructed with the click.Ĭlick on where you want to begin the duct. Download Autodesk AutoCAD MEP Direct Link Program for mechanical and electrical designers and planners of plumbing installations and for the design. Design and document building systems with the AutoCAD MEP (mechanical, electrical, plumbing) toolset. The previewed duct can be adjusted by hovering your cursor around to extend the length, and to the properties palettes to edit the properties of the duct segment to form. Preview will be shown for every segment of duct right before you click on where you want that segment to stops. We can set properties for the duct (Sizes, Types, Elevation, Fittings) after a duct is constructed, or more easily, during the preview mode before the duct is formed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |